NOTE: Calibration is a critical step in setting up your scanner. It allows the image quality to be “balanced” for your computer and scanner combination. If at any time you switch the computer that you use with your scanner, or change scanners, you will be required to calibrate again.
To launch the DocketSCAN II application you can either double-click the DocketSCAN II icon in your system tray or shortcut icon on your desktop or the “Taskbar tray” icon (usually in the lower right-hand corner of the Windows desktop).
Once you have launched DocketSCAN II® for the first time, you should select the SCAN button and the step-by-step calibration instructions will appear in a succession of prompts.
This calibration process will require the special black and white calibration sheet that was included with your scanner.
When calibrating make sure the page with the black bars are facing down and note the direction of the arrows for proper insertion.
When the calibration process has been completed successfully, you will see the message above otherwise you would need to re-calibrate again.
If you switch scanners or your image quality has become unsatisfactory, you can re-calibrate your scanner by choosing the CUSTOM button in the DocketSCAN II® window and select the Calibrate button.
Should you lose or forget the black and white calibration paper that was included with your scanner, you can simply use any plain “white” (the brighter the “white” the better) piece of letter size (or A4) printer paper to perform the calibration. Simply fold the paper in half and insert the folded end into the scanner first when calibrating.
The following message will be displayed (see below).
Loading... 